ProCure®

HydroMax® internal curing admixture

HydroMax® HP

Conventional and high-performance concrete

HydroMax® High Performance (HP) is an engineered, SAP-based internal curing admixture that absorbs and releases water within concrete to support continued cement hydration. By making curing water available as internal moisture is consumed, HydroMax® helps reduce self-desiccation, autogenous shrinkage, and the potential for early-age cracking.

Product details

Illustration of a concrete bridge deck and its piers

Applications

  • Low-w/cm and high-performance concrete
  • Bridge decks, pavements, and parking structures
  • Slabs, floors, and other large exposed surfaces
  • Ready-mixed and precast concrete
  • Concrete containing supplementary cementitious materials (SCMs)
  • Placements in hot, dry, or windy conditions
  • Concrete exposed to freezing and thawing

Advantages

Depending on mixture proportions, materials, placement, and curing, HydroMax® HP may help:

  • Reduce self-desiccation, autogenous shrinkage, and the risk of early-age cracking
  • Support continued hydration and strength development
  • Improve durability and resistance to scaling, freezing, and thawing
  • Reduce permeability and improve resistance to moisture ingress

HydroMax® HP does not replace the specified surface cure. Freeze-thaw and scaling resistance require an appropriate air-void system.

Dosage and batching

0.15%–0.20% by weight of total cementitious materials. Confirm the dosage with trial batches using the proposed materials, or consult ProCure. Support any dosage outside this range with testing.

Bulk material

Use a calibrated bulk dispenser to weigh and introduce HydroMax® during batching. Follow the plant’s validated sequence and mix thoroughly before discharge to distribute it uniformly.

4.5 lb bags

After loading all other materials, bring the concrete to the top of the drum. At the slump rack, add HydroMax® directly onto the fresh concrete. Rinse the drum normally and mix for 5 minutes before discharge.

Verify batching sequence, mixing time, and uniform distribution through plant trials.

Compatibility and air entrainment

Other admixtures

HydroMax® HP contains no calcium chloride or other chloride-based ingredients. It can be used with other non-chloride admixtures. Dispense each admixture separately into the mix.

Air-entrained mixtures

At the recommended dosage, HydroMax® HP typically contributes approximately 2–4 percentage points to the measured air-void content of hardened concrete. Use trial batches and hardened air-void testing to establish the combined HydroMax® HP and air-entraining admixture dosages that meet the project requirements.

Specifications and handling

Standards and typical properties

Standard
Meets ASTM C494/C494M Type S
Appearance
Cream to yellow, dustless powder
pH in water
10.5–12.7
Bulk density
0.7 g/mL

For Type S testing, the reference and test mixtures were adjusted to equivalent air contents.

Packaging and storage

Packaging
4.5 lb (2 kg) bags and 2,000 lb (907 kg) super sacks
Storage
41°F–95°F (5°C–35°C) in unopened original containers. Protect from direct sunlight and freezing.
Shelf life
At least one year

Typical specification clause

“Concrete shall be internally cured with HydroMax® High Performance Internal Curing Admixture manufactured by ProCure. Material to be used in strict accordance with manufacturer’s instructions.”

Rev. 10/26. See the full sheet for warranty terms.

Technical support

Mix design assistance for HydroMax® HP

Contact ProCure for help incorporating internal curing into ready-mixed or precast concrete. We can review your materials, target w/cm, air requirements, and batching sequence.